Device
Connect
Control
Status
Module
| Connection status | |
| Hardware version | |
| Firmware version | |
| Up time | |
| Serial number | |
| Model number | |
| State |
Ethernet
| MAC address | |
| Status | |
| IP | |
| Netmask | |
| Gateway |
Wi-Fi Access Point
| MAC address | |
| Status | |
| SSID | |
| IP | |
| Netmask | |
| Gateway |
Wi-Fi Client
| MAC address | |
| Status | |
| SSID | |
| IP | |
| Netmask | |
| Gateway |
Settings
Settings I/O
Security
Trigger security
If enabled, codes submitted via Wi-Fi or Ethernet will require the following password to be entered before the code itself
i.e., `<ESC>p0` → `pass<ESC>p0`
| Enable trigger password | |
| Trigger password |
|
Site login credentials
| Username | |
| Password |
|
| Confirm password |
|
Networking
| mDNS hostname | |
| TCP port |
Ethernet
| Enabled | |
| Connection type |
Static IP
| Static IP | |
| Netmask | |
| Gateway |
Wi-Fi Access Point
| Enabled |
On startup the hotspot will be live for 10 minutes
|
|
| SSID | ||
| Password |
|
|
| IP | ||
| Netmask | ||
| Gateway |
Wi-Fi Client
| Enabled | |
| SSID | |
| Password |
|
| Connection type |
Static IP
| Static IP | |
| Netmask | |
| Gateway |
USB
| Enabled |
Warning! If USB is disabled, you will no longer be able to configure the device via USB.
|
|
| USB Type |
Warning! If USB type is set to Host, you will no longer be able to configure the device via USB.
|
Command codes
Below are configurable command codes and their associated actions.
e.g., entering '<ESC>p0' will trigger relay 1.
Non-printable characters are entered using their control code representation.
e.g., '<ESC>' or '<0x1B>'
| Code | Echo | Trigger 1 | Trigger 2 | Remove |
|---|---|---|---|---|
RFID Reader
| Enabled | |
| Tag Event Report Format |
Read Zones
| Read Zone ID | Antennae | Read Power (dBm) | Start delay (ms) | ON duration (ms) | Session | Trigger Pin | Remove |
|---|---|---|---|---|---|---|---|
MQTT
| Enabled | ||
| Broker URI | ||
| Broker Port | ||
| Client ID | ||
| Heart Beat Interval (s) | 0 = No heart beat |
Trigger
| Send response on open | Sends `0x14 0x00 0x00 0x0f` | |
| Send response on close | Sends `0x10 0x00 0x00 0x0f` | |
| Invert status pin | Enable this if 'state' in Status is 'open' when it should be 'closed' | |
| Relay on-time | ||
| Relay trigger voltage |
You have unsaved changes!
Update Firmware
Instructions:
- Download the new firmware from an official UMD source
- M320AU (USB)
https://www.umd.com.au/m320/firmware_M320AU.bin - M320AW (Wi-Fi)
https://www.umd.com.au/m320/firmware_M320AW.bin - M320AE (Ethernet)
https://www.umd.com.au/m320/firmware_M320AE.bin - Click Choose file, and select the downloaded firmware
- Click Upload file
- Wait for the firmware to finish uploading to the module
- Check the firmware version in Status matches the downloaded firmware's version
Documentation
Please note that accessing the following links requires an internet connection.M320 Universal Trigger - Technical Manual